NEC EcoPowerGateway N8142-36F User Manual page 117

Messages displayed on lower line
When STATUS lamp is off:
On-screen
Description
message
SMI Timeout A timeout error
occurred during
system management
interrupt.
WDT Timeout Watchdog timer
timeout error
occurred.
Processor T- Forced power-off
Trip occurred due to a
thermal error in
processor.
Action
1. Take one of the following measures to reboot (reset)
the maintenance card.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
2. Take one of the following measures to power off the
maintenance card and then on.
* Press the Maintenance switch to power off the
maintenance card, then press it again to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
3. Power off the maintenance card by pressing the
POWER switch of EcoPowerGateway, then turn it on.
4. If the same error persists, contact your service
representative.
1. Take one of the following measures to reboot (reset)
the maintenance card.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
2. Take one of the following measures to power off the
maintenance card and then on.
* Press the Maintenance switch to power off the
maintenance card, then press it again to power on.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
3. Power off the maintenance card by pressing the
POWER switch of EcoPowerGateway, then turn it on.
4. If the same error persists, contact your service
representative.
1. Check if dust or stain is adhered to the fan of the
power unit or not.
2. Check if blank cover is surely installed in the slot
which does not contain any power unit.
3. Check the ambient temperature of installation
location.
4. Take one of the following measures to reboot (reset)
the maintenance card.
* Press Ctrl + Alt + Del.
* Issue a command from Web browser of
EXPRESSSCOPE Engine 2 or NEC ESMPRO
Manager.
Troubleshooting 6-11