NEC EcoPowerGateway N8142-36F User Manual page 60

3-4 Setting Up Your EcoPowerGateway
Installing/Removing the EcoPowerGateway in/from Rack
This subsection provides the instructions for installing the EcoPowerGateway into a rack cabinet.
(This subsection also describes the removal procedures.)
If you are going to use the non-NEC rack, make sure that the rack is compliant to EIA standard and
it can accept the EcoPowerGateway. Contact your service representative for applicable rack.
Observe the following instructions to use the EcoPowerGateway safely.
Failure to follow these instructions may result in death or serious personal
injury. See pages 1-4 to 1-16 for details.
Do not use any rack which does not conform to the relevant standard.
■
Always use the EcoPowerGateway in the specified place.
■
Observe the following instructions to use the EcoPowerGateway safely.
Failure to follow these instructions may cause a fire, personal injury, or
property damage.
See pages 1-4 to 1-16 for details.
Do not carry the EcoPowerGateway with the power units being installed.
■
Do not install the EcoPowerGateway in any other place than specified.
■
Do not install the EcoPowerGateway on the rack leaving the cover
■
removed.
Do not pinch your finger with mechanical components.
■
WARNING
CAUTION