NEC EcoPowerGateway N8142-36F User Manual page 28

1-12 Notes on Using Your EcoPowerGateway
CAUTION
Do not provide the wiring to exceed the rating of the power supply.
To prevent burns, fires, and device damages, the power supplied to the
power supply in the rack shall not exceed the rating load of the power branch
circuit. Contact your electric constructor or the local power company for the
requirements on the wiring and installation of electric facilities.
Do not carry or install the rack only by a single person.
At least two persons are required to carry or install the rack. Failure to follow
this instruction may cause the rack to fall to result in personal injury and/or
breakage of surrounding devices. In particular, a high rack (such as 44U rack)
is unstable if it is not fixed by stabilizers. At least two persons must always
carry or install the rack while they support it.
Do not install the rack and devices so that the load may be concentrated on a
specific point.
Install stabilizers on the rack so that the total load of the rack and devices
mounted on the rack is not concentrated on a singe point, or join more than
one rack with each other to distribute the load. Failure to follow this instruction
may cause the rack to fall to result in personal injury.
Do not install components on the rack only by a single person.
At least two persons are required to install components including the doors
and rails for the rack. Failure to follow this instruction may cause some
components to fall to be broken and/or to result in personal injury.
Insert hinges completely.
When installing the rack door, make sure that hinge pins at top and bottom of
the door are completely inserted into the rack. Failure to follow this instruction
may cause the door to fall to be broken and/or to result in personal injury.
Do not pull out a device from the rack if the rack is unstable.
Always pull out a device from the rack in the state that the rack is made stable
(by the installation of stabilizers or earthquake-resistant construction).
Do not leave more than one device being pulled out from the rack.
Pulling out more than one device from the rack may cause the rack to be
fallen. Only pull out a single device from the rack at a time.