NEC EcoPowerGateway N8142-36F User Manual page 65

Removing the EcoPowerGateway
Remove the EcoPowerGateway from the rack in the following procedure.
1.
Make sure that the EcoPowerGateway is off-powered, and disconnect the power cables
and all the interface cables from the EcoPowerGateway.
NOTE:
2.
While pushing the left and the right unlock buttons on the front of the EcoPowerGateway,
pull out the EcoPowerGateway from the rack slowly and carefully.
Push this button to unlock the EcoPowerGateway.
Observe the following instructions to use the EcoPowerGateway safely.
Failure to follow these instructions may cause a fire, personal injury, or
property damage. See pages 1-4 to 1-16 for details.
Do not pinch your finger with mechanical components.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the rack.
■
Do not pull out the EcoPowerGateway from the rack while it is operating.
■
Pay attention not to drop the EcoPowerGateway.
■
Make sure that the Power lamp at the front side is unlit.
Setting Up Your EcoPowerGateway 3-9
CAUTION