Information Codes Table (For Facsimile) - Panasonic DX-600 Service Manual

4.8.

Information Codes Table (For Facsimile)

Code Mode
001 RCV
COPY
002 RCV
COPY
007 RCV
COPY
008
010 RCV
COPY
011 STANDBY
017
030 XMT
031 XMT
COPY
041 STANDBY
RCV
COPY
043 STANDBY
RCV
COPY
045 STANDBY
060 -
061 -
400 XMT
Edition 1.0
Fax Information Codes
Phase Description of Problem
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (1st Cassette)
C, D Leading edge of the recording
paper fails to reach the Timing
Sensor. (2nd Cassette)
C, D 1. Leading edge of the recording
paper fails to reach the Paper
Exit Sensor.
2. Recording paper has not
completely passed the Paper
Exit Sensor.
Paper cassette is opened while
paper is feeding.
B, C No recording paper.
B, C Paper Cassette is not installed
properly.
Incorrect paper size loaded in the
Paper Cassette.
B Read Point Sensor does not go
ON within 10 seconds after the
document starts feeding.
C Transmitting document was longer
than 2 meter (or 78.7 in).
B, C, D Out of toner.
B, C, D Low toner.
- No Toner Cartridge.
A Printer Cover is open.
A ADF Door is open.
B T1 timer (35 ± 5 sec.) elapsed
without detecting 300 bps signal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Timing Sensor abnormal.
Recording paper jam.
Paper Exit Sensor abnormal.
Paper cassette is opened.
No recording paper or paper is not set
properly.
No Paper Sensor is defective.
Connector is not installed properly.
Paper size is incorrect.
Document is not set properly.
Defective Read Point Sensor.
The document may jam.
Defective Read Point Sensor.
No toner.
Defective Toner Sensor.
Toner is getting low.
Defective Toner Sensor.
Toner Cartridge has not been installed.
Defective Toner Sensor
(Cartridge Sensor).
Cover is not firmly closed.
Connectors are not firmly connected.
Door is not firmly closed.
Connectors are not firmly connected.
Wrong number is dialed and the START
button is pushed.
Telephone line is disconnected while
dialing.
SC PCB (Modem) or MJR PCB are
defective.
Receiver is defective. (It may only be
transmitting CED)
141
DX-600/800
Cause
APR 2002