Hitachi IJ RX2 Technical Manual page 142

When the operation guide "Replace ink filter -----" is displayed, replace ink
3
filter with a new one.
Circulation control
Process：Ink filter replacement
Operation guide
Replace ink filter with a new one.
Put ink into the ink reservoir.
When ready press [Start/Continue].
(
a) Disconnect piping joints C and D and connect them to a new ink filter.
Piping joints C
Use ink filter
The joints cannot be installed if the installation position of the piping is incorrect.
1
(C is at the center of the ink filter and D is at the outside.)
2
When installing, always lock piping joints C and D by turning them clockwise.
A small amount of ink will remain inside the ink filter even after ink drainage.
3
Be careful that the ink does not spill when handling the used ink filter.
6-19 ●Replacing the ink filter
[Service ]
Proc. status:
［Disconnect piping joints］
Piping joints D
C D
Lock release
2015.07.07 12:45
Com=0
Ink Drainage
Ink rep.
Ink refill
Abort
Start/Continue
C D
New ink filter
CAUTION
［Connect piping joints］
C D
C D