Hitachi IJ RX2 Technical Manual page 161

(e) Open the "Circulation control" screen, and press the Ink stream alignment key and
then the Start/Continue key.
● Check if the ink stream is going into the gutter and it's in the center of the gutter.
● Check whether the gutter absorbs the liquid.
If the ink is not being ejected, press Ink stream alignment key again. An ink fixing may
be caused if the ink is not ejected after Ink stream alignment is conducted two times.
An ink fixing may be caused if the suction of the liquid.
A special work is required for restoration. Contact your local distributor.
If the "Ink steam bending" occurs, refer to Technical manual "6.4 How to correct ink
stream bending and nozzle clogging" for restoration. If the ink stream bending is not
corrected, a special work is required. Contact your local distributor.
Operating procedure- "Process after long-term shutdown"
2
(a) Open the "Circulation control" screen, and press the
Process after long-term shutdown key then the Start/Continue key.
Circulation control
(Goes to Standby)
Nozzle backwash
Ink replacement
Process prior to
long-term shutdown
Select option; press [Start/Cont.]
(b) Follow the on-screen instructions for the operation.
● Repeat twice the same procedure as in "6.3 Replacing the ink".
(c) At the end of operation, screen returns to the Circulation control screen.
Put the end of print head into the beaker then press Ink refill key and Start/Continue
key. The ink will be ejected in a few minutes.
If the ink does not eject after pressing Ink refill key and Start/Continue key or "Ink
pressure low" or "No ink drop charge" is displayed, a special work is required for
restoration. Contact the local distributor near you.
CAUTION
[Stop ]
Eject ink
Cleaning stop
Recovery-line
cleaning
Ink filter
replacement
Process after
long-term shutdown
Proc. status:
CAUTION
2015.07.07 12:45
Com=0
No-cleaning stop
HOME
Prev.Dsp. Next Dsp.
Ink circulation
Cancel
Makeup refill
Start/Continue
Start/Continue
●Long-term Shutdown 6-38