Hitachi IJ RX2 Technical Manual page 158

Open the "Circulation control" screen, and press the
1
Process prior to long-term shutdown key and the Start/Continue key.
Circulation control
(Goes to Standby)
Nozzle backwash
Ink replacement
Process prior to
long-term shutdown
Select option; press [Start/Cont.]
The following guidance appears. Confirm the message and Press
2
Start/Continue key.
Circulation control
Process : Process prior to
Operation guide
Always pay attention to the following before operation.
・Depending on the ink types, storage temperature or storage
・For the storing method, it is recommended contact your
Drain the Ink from the ink filter and ink circulation system.
3
(1) Perform
● Perform from ink drainage to place the ink reservoir tube connection block back into position.
● Perform operation in accordance with the operation guide on the screen.
(2) Return the direction of the ink filter so that connected tubes become the top.
Cleaning of the circulation system starts.
4
● Perform operation in accordance with the operation guide on the screen.
Circulation control
Process : Process prior to
Operation guide
Remove the tube connection block from reservoir
and clean the end of it.
And then place the tube connection block in a beaker charged
with 50ml of makeup.
When ready, press <Start/Continue>.
6-35 ●Long-term Shutdown
[Stop ]
Eject ink
Cleaning stop
Recovery-line
cleaning
Ink filter
replacement
Process after
long-term shutdown
Proc. status:
[Stop ]
long-term shutdown
term the clogging formed by residual ink the circula-
tion system may occur even if this process is performed.
local distributor.
Proc. status:
-(a) to -(c) of the procedure in "6.3 Replacing the ink".
2 2
[Service ]
long-term shutdown
2015.07.07 12:45
Com=0
No-cleaning stop
HOME
Prev.Dsp. Next Dsp.
Ink circulation
Cancel
Makeup refill
Start/Continue
2015.07.07 12:45
Com=0
InkDrainage
Systemclean
InkDrainage
Systemclean
InkDrainage
Systemclean
Abort
Start/Continue
2015.07.07 12:45
Com=0
InkDrainage
Systemclean
InkDrainage
Systemclean
InkDrainage
Systemclean
Start/Continue
Start/Continue