Hitachi IJ RX2 Technical Manual page 35

Lead-in port connection method
[Lead-in port]
Seal Lock nut
Remove the lock nut.
1
Pass the cable through as shown
2
in the figure.
3 Tighten the lock nut.
(
Tighten the lock nut securely
using a tool.
Cable
Seal
1 Remove the set screw and remove
the cable seal block from the body.
2
Separate the cable seal block.
3
Wrap the outside of the cable with
)
seal as shown in the figure.
(
Wrap the seal so that there is
no gap between it and the cable
seal block.
4
Reassemble the cable seal block by
following the opposite procedure.
Set screw
Cable seal block
Cable seal block
Cable
)
●Input/output (I/O) signal connection 4-4