Hitachi IJ UX Instruction Manual page 143

Print start delay
6
●The printing start position can be specified.
●After setting in character units or mm units, fine adjust in scan units.
●When you want to input in mm units, input "Line speed".
●The positional relationship between the sensor and nozzle is as indicated below.
When the nozzle is positioned before the sensor
Sensor
c
a
0 0 2 3
b
Nozzle center
Print start delay=a-b (mm)
●Specify the print start delay (printing start position) as suggested below.
(i) Measure the length of the print start delay.
(ii) Measure the inter-character distance (C).
(iii) Divide the value obtained in (i) by the value obtained in (ii). Enter the resulting value.
a+b
c
●When a product speed matching function is not provided, if the ink drop use percentage, character
width, character size or number of lines is changed, the set value of the print start delay can be adjusted
so that the time until printing starts will not change.
●When a product speed matching function is provided, if the pulse rate division actor is changed, the set
value of the print start delay can be adjusted so that the time until printing starts will not change.
Print specifications
Screen switching
Message name [ ]
Direction of transport
Print target
: Setting value
2nd screen of "Print specifications" screen
1st screen 2nd screen
Product speed matching
None
０００００
Line speed [m/min.] Input '0' if unknown
Pulse rate div. Factor ００１
Disable
Speed compensation
Speed compensation fine control
Distance between print head and work
Repeat print
Repeat count (0: none, 1∼9998, 9999: Continuous) ００００
０００００
Repeat intervals （0∼99999）SC
When the nozzle is positioned after the sensor
Sensor
c
a
0 0 2 3
b
Nozzle center
Print start delay=a+b (mm)
[Stop ]
Com=0
Makeup
3rd screen
Encoder Auto
（1/1∼1/999 Enter denominator.）
Enable
００００
(-50∼+50)SC
[mm]
００
Direction of transport
Print target
2015.07.07 12:45
Ink
Startup
Manual
HOME
Edit
message
Print
format
Changes the repeat
intervals input units.
Change unit
Back
●Set the print specifications 4-80