Hitachi IJ UX Instruction Manual page 240

(3) When a mistake was generated or when processing judgment is prompted
(a) Previous HMI
Message No.
(b) New HMI
The name of the confirmation
message is displayed.
●The contents of the confirmation message are described at the place of each operation.
(4) Guidance for Fault / Waring
(a)Previous HMI
9-3 ●Display when warning or fault was generated
The name of the confirmation
message is displayed.
===== Ink Jet Startup Confirmation
186
The ink jet will be turned ON.
Solution To turn the ink jet ON, press <Ready>.
Ready
Ink Jet Startup Confirmation
The ink jet will be turned ON.
Solution 1. To change the printer status to Ready, press <Ready>.
2. To change the printer status to Standby, press <Eject ink>.
Ready
Print description
Message name[ ]
−
002 ◆◆◆◆◆ Main Ink Tank Too Full
The ink level in the main ink tank is too high.
Cause 1. The valve (MV2) or valve (MV7) is faulty.
2. The High Level sensor in the main ink tank is faulty.
Ink operating time １００(hours)
Solution 1. Drain proper amount of ink in the main ink tank.
Cumulative op. time １００(hours)
2. Check the High Level sensor.
Print count １０００(prints)
3. Contact your local distributor.
Ink pressure ０．０００(MPa；standard value:０．２５０)
Reset
Change
Select Overwrite
message message message
The description, cause,
and solution are displayed.
CONFIRMATION
Eject ink
[Stop ]
Com=0
Current user ID : user2
＋
Makeup Ink
Adjust print Operation
parameters management
The description, cause,
and solution are displayed.
=====
Close
Message No.
×
No.050
Cancel
2015.07.07 12:45
Startup
Manual
Press HELP , then the
guidance will appear.
Inter-
HELP
laced
Print count
reset
Close
Menu