Fine Adjust The Print Specifications (Adjust Print Parameters) - Hitachi IJ UX Instruction Manual

6
Reverse scan printing (UX-D,E only)
●Selects whether or not reverse scan control which deflects the particles in the reverse order of the
conventional order is to be used.
●The printing tilt when the print target is transported at high speed becomes smaller than the
conventional control system.
Refer to "9. Appendix" of the technician's manual for more information.

4.14.4 Fine adjust the print specifications (Adjust print parameters)

(1) Function
●Starts from the Print description screen.
●Current message print specifications "character height", "character width", "print start delay" and "Pulse rate
div. Factor" settings are easily set.
●Since changes to the set value are immediately reflected in the printing, the changes be easily confirmed while
printing.
●After setting in character units or mm units, fine adjust in scan units.
●When you want to input in mm units, input "Line speed" in the print specifications screen.
(a) Previous HMI
"Adjust print parameters" screen
Adjust print parameters
Message name [ ]
−
−
Character height （0∼99） ８ ５
Character width （0∼3999） −
０ ０ ０ ２
（0∼9999）SC
Print start delay
−
０ ０ ０ ０
Pulse rate div. Factor −
０ ０ １
[Stop ]
Com=0
Makeup
＋
＋
＋
＋
(1/1∼1/999 Enter
＋
denominator.)
2015.07.07 12:45
Ink
Startup
Manual
HOME
Change unit
Save
Back
●Set the print specifications 4-90