Hitachi IJ UX Instruction Manual page 246

No.
Target Sensor Time
52
Out
Target Spacing Too
53
Close
Print Data
54 Changeover In
Progress S
56 Blank Print Items
Excessive Format
57
Count
Print Data
58 Changeover In
Progress M
Print Data
59 Changeover In
Progress V
Communication
60
Buffer Fault
Internal
62 Communication
Error C
Internal
63 Communication
Error M
Ink Level Sensor
245
Broken 1
Makeup Level
246
Sensor Broken 1
Ink Level Sensor
254
Broken 3
Makeup Level
255
Sensor Broken 3
9-9 ●On-screen message descriptions
Message
The print target detecter signal was ON
longer than the timeout setting of Target
Sensor Timer.
There are 5 or more print target detector
signal turned ON before print start during
printing at No repeat print setting.
A print operation was requested while the
print data was being changed.
The print items are not properly set up.
A column has more than 8 print format
types (the number of lines, line spacing,
character size, character spacing, bold
charcter and bar code).
A print operation was requested while the
print data was being changed.
A print operation was requested while the
video data was being changed.
The print contents are not in the
communication buffer.
The internal data processing error.
The internal data processing error.
The level sensor in the ink reservoir does
not work properly.
The level sensor in the makeup reservoir
does not work properly.
The replacement of the Makeup Cartridge
will be temporarily disabled until "Makeup
Low Waring" appears.
The level sensor in the ink reservoir does
not work properly.
The level sensor in the makeup reservoir
does not work properly.
Meaning of message Remedy
● If the target is stopped in front
of the sensor, move the target.
● Change the Target Sensor
Timer setting.
( 4.14.1).
● Move the print target detecter
closer to the print head.
● If the target signal is
chattering, Use Sensor filter
setting.
● Change of timing either print
data change or print start.
● Change the print data.
● Perform setup so that the
number of print format types
does not exceed 8.
● Change timing of either print
data change or print start.
● Adjust either the encoder
frequency or the pulse rate
division factor.
● Change timing of either print
data change or print start.
.● Adjust the print and
communication timing.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.
● Contact your nearest local
distributor.