Siemens SINUMERIK 840Di sl Operating Manual page 45
Hide thumbs
Also See for SINUMERIK 840Di sl:
- Commissioning manual (632 pages) ,
- Programming manual (560 pages) ,
- Function manual (274 pages)
Table of Contents
Advertisement
2
01/2008
© Siemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
24 Wait:
For tool change acknowledgement
25 Wait:
For gear stage change
26 Wait:
For position control
27 Wait:
For thread cut
29 Wait:
For punching
30 Wait:
For safe operation
32 Stop:
Oscillation active
33 Stop:
Axis replacement active (block change inhibited
because axis replacement in progress)
34 Wait:
For axis container rotation
35 Wait:
AXCT axis active as slave axis
36 Wait:
AXCT axis active as master axis
37 Wait:
AXCT axis changing to follow-up
38 Wait:
AXCT internal status change in axis
This delay status may be attributable to the following
causes:
• Activation of position control
• Requesting of zero marker
• Reference point approach active
• Parameter block change active
• Measuring system change active
• Measurement on-the-fly active
• Closed-loop controller enable removed
• Status change, axis/spindle disable
39 Wait:
AXCT axis drive disable
40 Wait:
AXCT axis overlaid motion active
41 Wait:
AXCT axis axis replacement active
42 Wait:
AXCT axis interpolator active
43 Wait:
WAIT_FOR_CC_ENABLE:
Waiting for compile cycle
44 Wait:
On access to system variable
46 Stop:
ESR triggered
47 Wait:
Axis container rotation waiting for spindle stop
48 Wait:
Axis container rotation waiting for synchronization of
MD data (New-Config)
Operator Components/Operating Sequences
2.4
Screen layout
2
2-45
Advertisement
Table of Contents
