Siemens SINUMERIK 840Di sl Operating Manual page 73

2
01/2008
© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
(Loads one file from one directory, in this case from the
subprogram directory SPF.DIR)
SELECT [source] [destination] [
The SELECT instruction selects a program for execution. The
selected program must be loaded into the working memory of the NC.
It can then be started with NC Start.
If programs on the hard disk must be executed, then the command
must include the keyword DISK.
[source]
is the name of the main program which is selected for execution in a
specific channel in the NCK.
[destination]
A channel must be specified as the destination.
CH=
Channel number (for a 1:1 link only);
or
with NETNAMES:INI: Channel name (channels are unambiguously
distributed across all NCs);
or
NC name, channel number
Example:
CH=2
(2, corresponds to the channel number)
CH=Station5
(Station5, corresponds to channel name from
NETNAMES.INI)
CH=ncu_b,1
(ncu_b, corresponds to the NCU name from NETNAMES.INI
1, corresponds to the local channel number of this NCU)
[DISK]
can be optionally specified for program execution from hard disk.
Examples:
SELECT PART12 CH=CHANNEL22
SELECT PART12 CH=NCU_2,2
(PART2 is selected in the 2nd channel of NCU_2)
SELECT /shaft1.wpd/side1.mpf CH=2 DISK
(Part program PAGE1.MPF of workpiece SHAFT1.WPD
is executed from hard disk in the 2nd channel)
Operator Components/Operating Sequences
2.7
DISK]
2
Job list
2-73