Extended Help For Program Commands - Siemens SINUMERIK 840Di sl Operating Manual
Hide thumbs
Also See for SINUMERIK 840Di sl:
- Commissioning manual (632 pages) ,
- Programming manual (560 pages) ,
- Function manual (274 pages)
Table of Contents
Advertisement
2
01/2008
Parameter
input
2.6.3 Extended help for program commands
© S iemens AG 2008 All rights reserved.
SINUMERIK 840Di sl/840D sl/840D Operating Manual HMI-Advanced (BAD) - 01/2008 Edition
If "Parameter input" appears in the vertical softkey bar, you can assign
parameters in an input screen for a particular instruction
(e.g., a cycle).
Function
You can call up a help function (quick help) to provide programming
support for editing part programs via the "information" key in the
program command editor.
If the quick help is not sufficient, you can also open the Programming
Guide (pdf file) by pressing the "information" key again. The command
you are looking for is highlighted in the document.
Sequence of operations
Prerequisite:
The cursor is positioned on a programming command (e.g. G01).
You can call up the help function (quick help) in the editor using the
"information" key.
Press the "information" key again to open the Programming Guide
(pdf file) with Adobe Acrobat Reader.
Operator Components/Operating Sequences
2.6
Calling the help function
2
2-69
Advertisement
Table of Contents
