Lenovo thinksystem SR630 Maintenance Manual page 100

Before installing the rear hot-swap drive assembly, touch the static-protective package that contains the new
rear hot-swap drive assembly to any unpainted surface on the outside of the server. Then, take the new rear
hot-swap drive assembly out of the package and place it on a static-protective surface.
To install the rear hot-swap drive assembly, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
Step 1. Gently press and hold the tab on the rear hot-swap drive assembly as shown and remove the air
baffle from the rear hot-swap drive assembly.
Figure 81. Air baffle removal
Step 2. Connect the SAS signal cable to connector
to connector 2
92
ThinkSystem SR630 Maintenance Manual
on the rear backplane.
1
on the rear backplane and connect the power cable