Remove The Front I/O Assembly; Install The Front I/O Assembly - Lenovo thinksystem SR630 Maintenance Manual

Remove the front I/O assembly

Use this information to remove the front I/O assembly.
Before removing the front I/O assembly:
1. Remove the top cover. See "Remove the top cover" on page 42.
2. If the security bezel is installed, remove it. See "Remove the security bezel" on page 51.
3. Disconnect cables of the front I/O assembly from the system board.
To remove the front I/O assembly, complete the following steps:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
Table 18. Front I/O assembly removal
Figure 108. Server models with four
3.5-inch drive bays
Step 1. Remove the screws that secure the front I/O assembly.
Step 2. Slide the front I/O assembly out of the assembly bay.
If you are instructed to return the old front I/O assembly, follow all packaging instructions and use any
packaging materials that are provided.

Install the front I/O assembly

Use this information to install the front I/O assembly.
112
ThinkSystem SR630 Maintenance Manual
Figure 109. Server models with eight
2.5-inch drive bays
Figure 110. Server models with ten
2.5-inch drive bays