Install The Rear Backplane - Lenovo thinksystem SR630 Maintenance Manual

Install the rear backplane

Use this information to install the rear backplane.
Before installing the rear backplane, touch the static-protective package that contains the new rear
backplane to any unpainted surface on the outside of the server. Then, take the new rear backplane out of
the package and place it on a static-protective surface.
To install the rear backplane, complete the following steps:
Watch the procedure. A video of the installation process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku: http://list.youku.com/albumlist/show/id_50462008
Step 1. Align the rear backplane with the rear hot-swap drive cage and lower it into the rear hot-swap drive
cage.
Figure 73. Rear backplane installation
Step 2. Connect the SAS signal cable and power cable to the rear backplane as shown.
.
Chapter 3 Hardware replacement procedures
83