Install The Backplane For Ten 2.5-Inch Hot-Swap Drives - Lenovo thinksystem SR630 Maintenance Manual

Before removing the backplane:
1. Remove the top cover. See "Remove the top cover" on page 42.
2. Remove all the installed drives and drive fillers from the drive bays. See "Remove a hot-swap drive" on
page 65 and "Install a hot-swap drive" on page 66.
3. Disconnect the cables from the backplane.
To remove the backplane, complete the following step:
Watch the procedure. A video of the removal process is available:
• Youtube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C_GGjNudxYy8-c69INMcmE
• Youku:
http://list.youku.com/albumlist/show/id_50462008
Figure 69. Removal of backplane for ten 2.5-inch hot-swap drives
Step 1. Grasp the backplane and carefully lift it out of the chassis.
If you are instructed to return the old backplane, follow all packaging instructions and use any packaging
materials that are provided.

Install the backplane for ten 2.5-inch hot-swap drives

Use this information to install the backplane for ten 2.5-inch hot-swap drives.
80
ThinkSystem SR630 Maintenance Manual