Enabling Snmp Notifications For Mpls Te; Displaying And Maintaining Mpls Te - HP FlexNetwork 10500 Series Configuration Manual

Step
1. Enter system view.
2. Enter MPLS TE view.
3. Set the interval for selecting
an optimal bypass tunnel.

Enabling SNMP notifications for MPLS TE

This feature enables generating SNMP notifications for MPLS TE upon MPLS TE state changes, as
defined in RFC 3812. For MPLS TE event notifications to be sent correctly, you must also configure
SNMP on the device. For more information about SNMP configuration, see the network
management and monitoring configuration guide for the device.
To enable SNMP notifications for MPLS TE:
Step
1. Enter system view.
2. Enable SNMP
notifications for MPLS TE.

Displaying and maintaining MPLS TE

Execute display commands in any view and reset commands in user view.
Task
Display information about explicit paths.
Display link and node information in an IS-IS
TEDB.
Display sub-TLV information for IS-IS TE.
Display network information in an IS-IS TEDB.
Display IS-IS tunnel interface information.
Display DS-TE information.
Display bandwidth information on MPLS
TE-enabled interfaces.
Display information about discovered PCEs.
Display PCC and PCE peer information.
Display PCC and PCE statistics.
Display MPLS TEDB information.
Command
system-view
mpls te
fast-reroute timer interval
Command
system-view
snmp-agent trap enable te
Command
display explicit-path [ path-name ]
display isis mpls te advertisement [ [ level-1 |
level-2 ] | [ originate-system system-id | local ] |
verbose ] * [ process-id ]
display isis mpls te configured-sub-tlvs [ process-id ]
display isis mpls te network [ [ level-1 | level-2 ] |
local | lsp-id lsp-id ]* [ process-id ]
display isis mpls te tunnel [ level-1 | level-2 ]
[ process-id ]
display mpls te ds-te
display mpls te link-management
bandwidth-allocation [ interface interface-type
interface-number ]
display mpls te pce discovery [ ip-address ]
[ verbose ]
display mpls te pce peer [ ip-address ] [ verbose ]
display mpls te pce statistics [ ip-address ]
display mpls te tedb { { isis { level-1 | level-2 } | ospf
area area-id } | link ip-address | network | node [ local |
mpls-lsr-id ] | summary }
103
Remarks
N/A
N/A
By default, the interval is 300
seconds.
Remarks
N/A
By default, SNMP notifications for
MPLS TE are enabled.