HP FlexNetwork 10500 Series Configuration Manual page 353

Figure 91 Network diagram
Site 1
CE 1
Table 32 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
Configuration procedure
1. Configure VLANs and add ports to VLANs on each switch. (Details not shown.)
2. Configure CE 1.
<CE1> system-view
[CE1] interface vlan-interface 10
[CE1-Vlan-interface10] ip address 100.1.1.1 24
[CE1-Vlan-interface10] quit
3. Configure PE 1:
# Configure an LSR ID.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 192.2.2.2 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 192.2.2.2
# Enable L2VPN.
[PE1] l2vpn enable
# Enable global LDP.
[PE1] mpls ldp
[PE1-ldp] quit
# Configure VLAN-interface 23 (the interface connected to the P device), and enable LDP on
the interface.
[PE1] interface vlan-interface 23
[PE1-Vlan-interface23] ip address 23.1.1.1 24
[PE1-Vlan-interface23] mpls enable
[PE1-Vlan-interface23] mpls ldp enable
MPLS or IP backbone
Loop0
Vlan-int23
Vlan-int23
GE1/0/1
PE 1
Vlan-int10
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int23 23.1.1.1/24
Vlan-int10 100.1.1.2/24
Loop0 Loop0
Vlan-int26
Vlan-int26
P PE 2
Vlan-int10
Device
P
PE 2
344
GE1/0/1
Site 2
CE 2
Interface IP address
Loop0 192.4.4.4/32
Vlan-int23 23.1.1.2/24
Vlan-int26 26.2.2.2/24
Loop0 192.3.3.3/32
Vlan-int26 26.2.2.1/24