Establishing An Inter-Area Mpls Te Tunnel Over A Crlsp Calculated By Pces - HP FlexNetwork 10500 Series Configuration Manual

Reverse-LSP LSR ID
Class Type
Reserved Bandwidth
Setup Priority
Affinity Attr/Mask
Explicit Path
Backup Explicit Path : -
Metric Type
Record Route
FRR Flag
Backup Bandwidth Flag: Disabled
Backup Bandwidth
Bypass Tunnel
Route Pinning
Retry Limit
Reoptimization
Backup Type
Auto Bandwidth
Min Bandwidth
Collected Bandwidth
# Verify that Switch A has a static route entry with interface Tunnel1 as the output interface.
[SwitchA] display ip routing-table
Destinations : 14
Destination/Mask
1.1.1.9/32
2.2.2.9/32
3.3.3.9/32
4.4.4.9/32
7.1.1.0/24
7.1.1.1/32
10.1.1.0/24
10.1.1.1/32
20.1.1.0/24
100.1.2.0/24
127.0.0.0/8
127.0.0.1/32
Establishing an inter-area MPLS TE tunnel over a CRLSP
calculated by PCEs
Network requirements
Switch A, Switch B, Switch C, and Switch D support MPLS TE and run OSPF.
Configure Switch A and Switch B as PCEs, and configure Switch C as a PCC to automatically
discover the PCEs.
: -
: CT0
: 2000 kbps
: 7
: 0/0
: atod
: TE
: Disabled
: Disabled
: -
: No
: Disabled
: 10
: Disabled
: None
: Disabled
: -
: -
Routes : 14
Proto Pre Cost
Direct 0 0
O_INTRA 10 1
O_ASE 150 1
O_ASE 150 1
Direct 0 0
Direct 0 0
Direct 0 0
Direct 0 0
O_ASE 150 1
Static 1 0
Direct 0 0
Direct 0 0
121
Reverse-LSP Tunnel ID: -
Tunnel Bandwidth
Holding Priority
Record Label
Bandwidth Protection : Disabled
Backup Bandwidth Type: -
Auto Created
Retry Interval
Reoptimization Freq
Backup LSP ID
Auto Bandwidth Freq
Max Bandwidth
NextHop Interface
127.0.0.1 InLoop0
10.1.1.2 Vlan1
10.1.1.2 Vlan1
10.1.1.2 Vlan1
7.1.1.1 Tun1
127.0.0.1 InLoop0
10.1.1.1 Vlan1
127.0.0.1 InLoop0
10.1.1.2 Vlan1
0.0.0.0 Tun1
127.0.0.1 InLoop0
127.0.0.1 InLoop0
: 2000 kbps
: 7
: Disabled
: No
: 2 sec
: -
: -
: -
: -