Configuring Ldp Pw Redundancy - HP FlexNetwork 10500 Series Configuration Manual

[CE2] interface vlan-interface 10
[CE2-Vlan-interface10] ip address 100.1.1.2 24
[CE2-Vlan-interface10] quit
Verifying the configuration
# Verify that a remote CCC connection (identified by PW ID/Rmt Site "-" and Proto Static) has been
established on PE 1.
[PE1] display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: ccc
Peer
10.1.1.2
# Verify that a remote CCC connection has been established on PE 2.
[PE2] display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 1
1 up, 0 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: ccc
Peer
10.2.2.2
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring LDP PW redundancy

Network requirements
Create two LDP PWs to implement PW redundancy between CE 1 and CE 2. The primary PW goes
through PE 1—PE 2. The backup PW goes through PE 1—PE 3. When the primary PW fails, CE 1
and CE 2 communicate through the backup PW.
PW ID/Rmt Site In/Out Label
- 101/201
PW ID/Rmt Site In/Out Label
- 202/102
Proto
Static
Proto
Static
355
Flag Link ID State
M 0 Up
Flag Link ID State
M 0 Up