HP FlexNetwork 10500 Series Configuration Manual page 404

Configure an Ethernet service instance on GigabitEthernet 1/0/1 to match packets with an outer
VLAN ID of 100 on each PE. Bind the Ethernet service instance to the VSI to forward the matching
packets through the VSI.
Figure 104 Network diagram
VPN 1
CE 1
Configuration procedure
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure an IGP and public tunnels on each PE. (Details not shown.)
2. Configure PE 1:
# Configure basic MPLS.
<PE1> system-view
[PE1] interface loopback 0
[PE1-LoopBack0] ip address 1.1.1.9 32
[PE1-LoopBack0] quit
[PE1] mpls lsr-id 1.1.1.9
[PE1] mpls ldp
[PE1-ldp] quit
# Establish IBGP connections to PE 2 and PE 3, and use BGP to advertise VPLS label block
information.
[PE1] bgp 100
[PE1-bgp-default] peer 2.2.2.9 as-number 100
[PE1-bgp-default] peer 2.2.2.9 connect-interface loopback 0
[PE1-bgp-default] peer 3.3.3.9 as-number 100
[PE1-bgp-default] peer 3.3.3.9 connect-interface loopback 0
[PE1-bgp-default] address-family l2vpn
[PE1-bgp-default-l2vpn] peer 2.2.2.9 enable
[PE1-bgp-default-l2vpn] peer 3.3.3.9 enable
[PE1-bgp-default-l2vpn] quit
[PE1-bgp-default] quit
# Enable L2VPN.
[PE1] l2vpn enable
# Configure VSI aaa to use BGP to establish BGP PWs to PE 2 and PE 3.
[PE1] vsi aaa
Loop0
3.3.3.9/32
Vlan-int30
30.1.1.3/24
PE 3
PE 1
Vlan-int30
30.1.1.1/24 40.1.1.2/24
Vlan-int20
GE1/0/1
20.1.1.1/24 20.1.1.2/24
Loop0
1.1.1.9/32
VPN 1
GE1/0/1
CE 3
Vlan-int40
40.1.1.3/24
PE 2
Vlan-int40
GE1/0/1
Vlan-int20
Loop0
2.2.2.9/32
CE 2
395
VPN 1