HP FlexNetwork 10500 Series Configuration Manual page 142

Figure 37 Network diagram
IP network
Vlan-int10
Switch A
Loop0
Table 6 Interface and IP address assignment
Device
Switch A
Switch B
Configuration procedure
Before configuration, disable the spanning tree feature globally or map each VLAN to an MSTI. For
more information, see Layer 2—LAN Switching Configuration Guide.
1. Configure IP addresses and masks for interfaces. (Details not shown.)
2. Configure IS-IS to advertise interface addresses, including the loopback interface address, and
configure IS-IS TE. (Details not shown.)
3. Configure an LSR ID, and enable MPLS, MPLS TE, and RSVP-TE:
# Configure Switch A.
<SwitchA> system-view
[SwitchA] mpls lsr-id 1.1.1.9
[SwitchA] mpls te
[SwitchA-te] quit
[SwitchA] rsvp
[SwitchA-rsvp] quit
[SwitchA] interface vlan-interface 1
[SwitchA-Vlan-interface1] mpls enable
[SwitchA-Vlan-interface1] mpls te enable
Switch B
Loop0
Vlan-int1
Vlan-int1
Vlan-int4
Switch D
Vlan-int4
Loop0
Interface IP address
Loop0 1.1.1.9/32
Vlan-int1 10.1.1.1/24
Vlan-int4 30.1.1.1/24
Vlan-int10 100.1.1.1/24
Loop0 2.2.2.9/32
Vlan-int1 10.1.1.2/24
Vlan-int2 20.1.1.1/24
IP network
Vlan-int10
Vlan-int2
Vlan-int2
Vlan-int3
Loop0
Vlan-int3
Device Interface
Switch D Loop0
Vlan-int4
Vlan-int3
Switch C Loop0
Vlan-int2
Vlan-int3
Vlan-int10
133
Switch C
IP address
4.4.4.9/32
30.1.1.2/24
40.1.1.1/24
3.3.3.9/32
20.1.1.2/24
40.1.1.2/24
100.1.2.1/24