HP FlexNetwork 10500 Series Configuration Manual page 38

Step
5. Configure the LDP transport
address.
Configuring LDP IPv4 sessions parameters for Extended Discovery mechanism
Step
1. Enter system view.
2. Enter LDP view.
3. Specify an IPv4 LDP peer and
enter LDP peer view. The
device will send unsolicited
IPv4 Targeted Hellos to the
peer and can respond to IPv4
Targeted Hellos received from
the targeted peer.
4. Set the Keepalive hold time.
5. Set the Keepalive interval.
6. Configure the LDP transport
address.
Configuring LDP IPv6 sessions parameters for Extended Discovery mechanism
Step
1. Enter system view.
2. Enter LDP view.
3. Specify an IPv6 LDP peer and
enter LDP peer view. The
device will send unsolicited
IPv6 Targeted Hellos to the
peer and can respond to IPv6
Targeted Hellos received from
the targeted IPv6 peer.
Command
•
IPv4 LDP:
mpls ldp
transport-address
{ ipv4-address | interface }
•
IPv6 LDP:
mpls ldp
transport-address
ipv6-address
Command
system-view
mpls ldp
targeted-peer ipv4-address
mpls ldp timer keepalive-hold
timeout
mpls ldp timer
keepalive-interval interval
mpls ldp transport-address
ipv4-address
Command
system-view
mpls ldp
targeted-peer ipv6-address
29
Remarks
By default:
•
The LDP IPv4 transport
address is the local LSR ID if
the interface where you want
to establish an LDP session
belongs to the public
network. If the interface
belongs to a VPN, the LDP
IPv4 transport address is the
primary IP address of the
interface.
•
No LDP IPv6 transport
address is configured.
If the interface where you want to
establish an LDP session is
bound to a VPN instance, the
interface with the IP address
specified with this command must
be bound to the same VPN
instance.
Remarks
N/A
N/A
By default, the device does not
send IPv4 Targeted Hellos to
any peers, or respond to IPv4
Targeted Hellos received from
any peers.
By default, the Keepalive hold
time is 45 seconds.
By default, the Keepalive
interval is 15 seconds.
By default, the LDP transport
address is the LSR ID of the
local device.
Remarks
N/A
N/A
By default, the device does not
send IPv6 Targeted Hellos to
any peers, or respond to IPv6
Targeted Hellos received from
any peers.