HP FlexNetwork 10500 Series Configuration Manual page 429
Hide thumbs
Also See for FlexNetwork 10500 Series:
- Security configuration manual (596 pages) ,
- Configuration manual (428 pages) ,
- Specifications (42 pages)
Table of Contents
Advertisement
connectivity detection. The packets used to verify PW connectivity are collectively referred to as
VCCV packets. A PE transfers VCCV packets through an MPLS router alert label type control
channel (CC) to test PW connectivity. The MPLS router alert label type CC identifies a VCCV
packet by adding an MPLS router alert label before the PW label.
Before you configure MPLS ping for a PW, perform the following tasks:
1.
Create a PW class, and use the vccv cc command to configure the VCCV CC type in PW class
view.
2.
Create the PW, and use the PW class created in the previous step for the PW.
Perform the following task in any view:
Task
Use MPLS ping to verify the
connectivity of a PW.
Command
ping mpls [ -a source-ip | -c count | -exp exp-value | -h ttl-value | -m
wait-time | -r reply-mode | -rtos tos-value | -s packet-size | -t time-out |
-v ] * pw ip-address pw-id pw-id
420
Advertisement
Table of Contents
