Configuring An Intra-Domain Multi-Segment Pw - HP FlexNetwork 10500 Series Configuration Manual

# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)
# Manually switch to the backup PW on PE 1.
<PE1> l2vpn switchover peer 2.2.2.2 pw-id 20
# Verify that the PW switchover is successful on PE 1.
<PE1> display l2vpn pw
Flags: M - main, B - backup, BY - bypass, H - hub link, S - spoke link, N - no split horizon
Total number of PWs: 2
1 up, 1 blocked, 0 down, 0 defect, 0 idle, 0 duplicate
Xconnect-group Name: vpna
Peer
2.2.2.2
3.3.3.3
# Verify that CE 1 and CE 2 can ping each other. (Details not shown.)

Configuring an intra-domain multi-segment PW

Network requirements
As shown in
between PE 1 and P, and between P and PE 2.
Configure a multi-segment PW within the backbone to allow communication between CE 1 and CE 2.
The multi-segment PW includes a PW between PE 1 and P, and a PW between P and PE 2. The two
PWs are concatenated on P.
Figure 95 Network diagram
Site 1
CE 1
Table 36 Interface and IP address assignment
Device
CE 1
PE 1
CE 2
PW ID/Rmt Site
20
30
Figure 95, no public tunnel exists between the PEs, but an MPLS TE tunnel exists
MPLS backbone
Loop0
Vlan-int23
Tunnel1
Vlan-int23
GE1/0/1
PE 1
Vlan-int10
Interface IP address
Vlan-int10 100.1.1.1/24
Loop0 192.2.2.2/32
Vlan-int23 23.1.1.1/24
Vlan-int10 100.1.1.2/24
In/Out Label Proto
1151/1279 LDP
1150/1279 LDP
Loop0 Loop0
Vlan-int26
Tunnel2
Vlan-int26
P PE 2
Device
P
PE 2
361
Flag Link ID
M 1
B 1
GE1/0/1
Vlan-int10
Site 2
CE 2
Interface IP address
Loop0 192.4.4.4/32
Vlan-int23 23.1.1.2/24
Vlan-int26 26.2.2.2/24
Loop0 192.3.3.3/32
Vlan-int26 26.2.2.1/24
State
Blocked
Up