Chapter 5
Adding a Connecting Device
Devices (servers, power synchronized units, and ETERNUS DX/AF storage systems) that are to be power
synchronized can be added during system operation.
This chapter explains how to connect a power synchronized unit when these devices are added.
Make sure to check
AF before adding a device.
5.1
Connection Procedure When Adding a Server
This section describes how to connect the power synchronized unit to synchronize power with an added server.
For details about server installation, connection, and settings, refer to the manual provided with the server.
Procedure
1
Connect the server UPS unit for the added server to the power synchronized unit.
An example of a connection between server UPS units and a power synchronized unit is shown below.
For details about how to connect a server UPS unit to the power synchronized unit, refer to
Connecting the Server UPS Unit to the Power Synchronized Unit" (page
UPS unit for
Server#1
UPS unit for
Server#0
Power synchronized unit
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide (Power Synchronized Unit)
"Safety Precautions" (page 9)
Server#1
Added server
Server#0
Copyright 2017 FUJITSU LIMITED
or the manual provided with the server or the ETERNUS DX/
Power cord (for AC sensor)
(Must be obtained by customers)
SENSOR#1 port
65
57).
P3AM-8012-10ENZ0
"4.4.1