Displaying Or Adapting The Telegram Configuration; Overview - Siemens SINUMERIK 840D sl Configuration Manual

Configuring telegrams and drive units

5.6 Displaying or adapting the telegram configuration

5.6 Displaying or adapting the telegram configuration
5.6.1

Overview

You can call (Page 111) the telegram configuration via the properties of SINAMICS
Integrated or NX.
Using a user-defined telegram configuration
A telegram configuration which differs from a standard telegram configuration (Page 104)
due to adaptations of any kind is called a user-defined telegram configuration:
● Adapting the configured number of drives (Page 119)
● Other changes in the overview for telegram configuration (Page 112) or in the properties
for the send telegram (actual value) (Page 113) or receive telegram (setpoint value)
(Page 116):
– Adding or removing telegrams
– Adding telegram extensions
– Changing I/O start addresses
– Changing the telegram types used
The use of a user-defined telegram configuration leads to greater commissioning, upgrading
and migration effort, because you must make the adaptations redundantly (in the TIA Portal
and in SINUMERIK Operate) and these are not automatically imported during an upgrade or
migration.
You can reset (Page 109) the telegram configuration in the TIA Portal to the standard
telegram configuration.
110
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325