Configuring networks
4.1
Configuring an Ethernet Interface
Procedure
In order to set the Ethernet interface, proceed as follows:
1. In the network view, click the CP in the basic rack of the NCU.
2. Under the "Properties" tab in the inspector window, select the "PN/IE interface > Ethernet
addresses" entry.
3. Set the IP address matching your real configuration. If the PG/PC is connected to X127,
the following IP address applies:
Hardware factory setting on the NCU for socket X127
IP address: 192.168.215.1
Subnet mask: 255.255.255.0
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017
4
79