Siemens SINUMERIK 840D sl Configuration Manual page 172

Safety configuration
9.5 Availability of I/O addresses at the mode change
Refer to the "Change Safety Integrated mode" dialog or the "Info" inspector window to see
which I/O addresses are effected.
● The "Change Safety Integrated mode" dialog shows the components for which the default
I/O addresses are assigned.
Figure 9-7
● The "Info" inspector window shows which default I/O addresses were already assigned
for each individual telegram.
Figure 9-8
● You can also display an overview of the telegram settings by clicking "Address overview"
in the PLC properties.
172
"Change Safety Integrated mode" dialog: Default I/O addresses are not available
You can click the symbol in the "Go to" column in the "Info > General" inspector
window to display the relevant I/O address.
SINUMERIK STEP 7 Toolbox V14 SP1
Configuration Manual, 05/2017, A5E41846325