Panasonic VariCam LT Operating Manual page 204

Display
[CANNOT REPAIR!]
[CANNOT SAVE! FILE NAME IN USE]
[CARD FULL!]
[INVALID VALUE!]
[MISSING CLIP!]
[NO CARD!]
[NO FILE!]
[NO INPUT!]
[NO SD CARD!]
[UNKNOWN CONTENTS FORMAT!]
[UNKNOWN DATA!]
[USER CLIP NAME MODIFIED!]
[WRITE PROTECTED!]
During soft keyboard operation
Display
[CANNOT SET!]
[INVALID VALUE!]
[CANNOT SET!]
[NO INPUT!]
[CANNOT SET!]
[RETRY PASSWORD IS DIFFERENT!]
Network
Message
[CANNOT CONNECT!]
[CANNOT FIND FTP-SERVER!]
[LOGIN FAILED!]
[PING FAILED!]
[CANNOT ACCESS GATEWAY!]
[CHECK LAN SETTING]
[IP ADDRESS IS USED!]
[INVALID VALUE!]
Chapter 12 Maintenance — Warning system
Description
Content that cannot be repaired is selected.
A settings file of the same name exists on the SD
memory card.
The P2 card or SD memory card is full.
The data value you entered is invalid.
Shot marks cannot be attached to the clips unless all
clips recorded over multiple P2 cards are present.
No P2 or SD memory card is inserted.
The specified file does not exist.
No data is entered.
No SD memory card.
This is a warning of the contents for the version that is
not supported by the camera.
The metadata character code is invalid.
There is a problem with data in the file.
When adding a counter value to the clip name,
characters must be deleted.
The P2 card or SD memory card is write-protected.
Description
The entered value is invalid.
There is not input to the software keyboard.
The re-entered password is different.
Description
A connection to the network cannot be established.
The connection destination FTP server cannot be found.
Logging in to the connection destination FTP server
failed.
The [PING] failed.
The gateway server cannot be accessed.
The gateway server cannot be accessed.
The set IP address is being used by another device.
The entered data value is invalid.
– 204 –
Behavior and cause
Check the selected content.
Use another name to save the file.
Insert a card with free space available.
Enter data within the normal range.
The camera cannot handle a clip recorded over multiple
cards.
Insert the relevant media.
Check the file.
Enter data and then set.
Insert an SD memory card.
Match the device and content versions.
The metadata character code is UTF-8. Enter valid
characters using a viewer.
Create the file again.
For the counter addition setting, the user clip name plus
the counter value can only contain up to 100 bytes.
Characters in the clip name are automatically deleted
when the total number of characters exceeds this limit.
Insert write-accessible media.
Behavior and cause
Change the input value.
Enter the password.
Enter the correct reference password.
Measure
Check that the LAN settings are correct. Make sure that
the LAN cable is connected correctly and the network
you use is running.
Check that [MENU] → [SERVER URL] → [FTP CLIENT
SERVICE] → [SERVER URL] is correct.
Check that [MENU] → [PERIPHERAL] → [FTP CLIENT
SERVICE] → [LOGIN USER] and [LOGIN PASSWORD]
are correct.
Check that the LAN setting and [MENU] →
[PERIPHERAL] → [FTP CLIENT SERVICE] →
[SERVER URL] are correct. Check that the LAN cable is
connected correctly or the network is operating.
Check that the LAN settings are correct.
Check that the LAN settings are correct.
Consult your network administrator and set another IP
address.
Enter data in a valid range.