Configuration And Programming In Step 7; Profinet Integration Via Gsd File - Siemens SIDOOR ATD401W System Manual

Configuration and programming in STEP 7

Configuration
The configuration of the control unit ATD420W on PROFIBUS or ATD430W on PROFINET
is made via certified GSD files. This ensures compatibility with different industrial automation
systems.
Before configuring, you must import the relevant GSD file into the configuration tool, for
example STEP 7.
Programming
A function block is provided for quick and easy connection of an SIDOOR drive to a
SIMATIC controller via PROFIBUS or PROFINET communication.
8.1

PROFINET integration via GSD file

Install the GSD file (see GSD files
(http://support.automation.siemens.com/WW/view/en/61054703/133200)) in the applicable
configuration tool before configuring the SIDOOR ATD430W PROFINET controller.
After installation, you will find the ATD430W controller under the following category:
"PROFINET IO > Drives > SIDOOR"
Note
Configuration notes
• Modify the Ethernet or PROFINET settings according to the applicable system.
• Make sure that the I/O addresses start at the same value.
• When the system is configured, the device parameters are assigned the following default
values specified by the GSD:
Cycle time [ms]: "100"
You can find more information on the PROFINET functions and protocols supported in the
sections PROFINET module (Page 134)and PROFINET communication (Page 144).
254
ATD4xxW Door Controller for Industrial Applications
System Manual, 01/2017, A5E38080677-AB
8