Toshiba H7 Operation Manuals page 179

F825
RS485 Response Delay Time
Program Communication Setting Parameters
⇒
Settings
This parameter sets the RS232/485 response delay time.
RS485 Master Output
Program ⇒ Communication Setting Parameters
Settings
In a master/follower configuration, this setting determines the output parameter
of the master ASD that will be used to control the applicable follower ASDs.
Select No Slave if F806 is configured as a Master Output controller.
Otherwise, an EOI failure will result.
Settings:
No Slave (normal operation)
Frequency Reference
Output Command Frequency
Torque Command
Output Torque Command
Communication Error
Program ⇒ Communication Setting Parameters
Error
In the event of a communication error during a transmission, the command that
was transmitted may be cleared or held.
Settings:
Command Request Cleared
Command Request Held
#1 Scan Receive
Program ⇒ Communication Setting Parameters
Settings
Contact Toshiba's Marketing Department for information on this parameter.
#2 Scan Receive
Program ⇒ Communication Setting Parameters
Settings
Contact Toshiba's Marketing Department for information on this parameter.
172
Direct Access Number — F825
Communication
⇒
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Yes
Minimum — 0.00
Maximum — 2.00
Units — Seconds
Direct Access Number — F826
⇒ Communication
Parameter Type — Selection List
Factory Default — No Slave (normal
operation)
Changeable During Run — Yes
Direct Access Number — F830
⇒ Communication
Parameter Type — Selection List
Factory Default — Command Request
Cleared
Changeable During Run — Yes
Direct Access Number — F831
⇒ Scan Receive
Parameter Type — Selection List
Factory Default — Scan 0
Changeable During Run — Yes
Direct Access Number — F832
⇒ Scan Receive
Parameter Type — Selection List
Factory Default — Scan 0
Changeable During Run — Yes
F832
H7 ASD Operation Manual