Toshiba H7 Operation Manuals page 129

F391
Preset Speed Direction #11
Program Pattern Run Control Parameters
⇒
Determines the forward/reverse setting for the #11 Preset Speed (F290).
Preset Speed Direction #12
Program ⇒ Pattern Run Control Parameters
Determines the forward/reverse setting for the #12 Preset Speed (F291).
Preset Speed Direction #13
Program Pattern Run Control Parameters
⇒
Determines the forward/reverse setting for the #13 Preset Speed (F292).
Preset Speed Direction #14
Program ⇒ Pattern Run Control Parameters
Determines the forward/reverse setting for the #14 Preset Speed (F293).
Preset Speed Direction #15
Program Pattern Run Control Parameters
⇒
Determines the forward/reverse setting for the #15 Preset Speed (F294).
Vector Motor Model Autotune Command
Program ⇒ Motor Parameters
This parameter sets the Autotune command status.
Settings:
Autotune Disabled
Reset Motor Defaults
Enable Autotune on Run Command
Vector Motor Model Slip Frequency Gain
Program Motor Parameters
⇒
This parameter provides a degree of slip compensation for a given load. A
higher setting here decreases the slip allowed for a given load/ASD output ratio.
122
Preset Speeds
⇒
⇒ Preset Speeds
Preset Speeds
⇒
⇒ Preset Speeds
Preset Speeds
⇒
⇒ Vector Motor Model
Vector Motor Model
⇒
Direct Access Number — F391
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Direct Access Number — F392
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Direct Access Number — F393
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Direct Access Number — F394
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Direct Access Number — F395
Parameter Type — Selection List
Factory Default — Forward
Changeable During Run — No
Direct Access Number — F400
Parameter Type — Selection List
Factory Default — Autotune Disabled
Changeable During Run — No
Direct Access Number — F401
Parameter Type — Numerical
Factory Default — 0.60
Changeable During Run — Yes
Minimum — 0.00
Maximum — 2.55
H7 ASD Operation Manual
F401