Panasonic AFPE224300 User Manual page 112

FP-e (A: Available, N/A: Not available)
Register
No.
Matsushita
IEC
DT9020
Not used
%MW5.9020
DT9021
Not used
%MW5.9021
DT9022 Scan time (current
value)
%MW5.9022
Scan time
DT9023
(minimum value)
%MW5.9023
Note)
Scan time
DT9024
(maximum value)
%MW5.9024
Note)
Mask condition
DT9025
monitoring register
%MW5.9025
for interrupts
DT9026
Not used
%MW5.9026
DT9027 Periodical interrupt
interval (INT24)
%MW5.9027
DT9028
Not used
%MW5.9028
DT9029
Not used
%MW5.9029
DT9030
Message 0
%MW5.9030
DT9031
Message 1
%MW5.9031
DT9032
Message 2
%MW5.9032
DT9033
Message 3
%MW5.9033
DT9034
Message 4
%MW5.9034
DT9035
Message 5
%MW5.9035
Note) Scan time display is only possible in RUN mode and shows the operation cycle time. (in PROG
mode, the scan time for the operation is not displayed.) The maximum and minimum values are
cleared each time the mode is switched from RUN to PROG.
11-14
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
-
-
The current scan time is stored here. Scan time
is calculated using the formula:
Note)
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K50 indicates 5 ms.
The minimum scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K50 indicates 5 ms.
The maximum scan time is stored here. The
scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K125 indicates 12.5 ms.
The mask conditions of interrupts using the
instruction can be stored here. Monitor using
binary display.
-
The value set by the ICTL instruction is stored.
K0: periodical interrupt is not used.
K1 to K3000: 0.5ms to 1.5s or 10ms to 30s
-
-
The contents of the specified message (Data
lenght) are stored in these special data registers
when F149 (MSG) instruction is executed.
Descriptions
Read Writ
-ing -ing
N/A N/A
A N/A
N/A N/A
A N/A
N/A N/A
A N/A