Panasonic AFPE224300 User Manual page 33

Suitable screwdriver
When tightening the terminals of the terminal block, use a screwdriver (Phoenix Contact Co. Product
No.1205037) with a blade size of 0.4 X 2.5 (Model No. SZS 0.4 X 2.5)
The tightening torque should be 0.22Nm to 0.25 Nm (2.3 kgfcm to 2.5 kgfcm)
Manufacturer
Phoenix Contact Co.
Wiring
1. Remove a portion of the wire's insulation.
2. Insert the wire into the terminal block until it contacts the back of the terminal block. Then, tighten the
screw clockwise to fix the wire in place.
Notes
-When removing the wire's insulation, be careful not to scratch the core wire.
-Do not twist the wires to connect them.
-Do not solder the wires to connect them. The solder may break due to vibration.
-After wiring, make sure stress is not applied to the wire.
-In the terminal block socket construction, if the wire closes upon counter-clockwise rotation, the
connection is faulty. Disconnect the wire, check the terminal hole, and then re-connect the wire.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Model No.
Parts No. Product No.
SZS0.4 X 2.5 1205037
Order product No.
AFP0806
3-7