Panasonic AFPE224300 User Manual page 218

Error
Name
code
MEWNET-F
slave I/O
E38 terminal
mapping
error
IC card
E39
read error
E40 I/O error
11-120
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Opera-
tion Description and steps to take
status
I/O mapping for remote I/O terminal
boards,remote I/O terminal units and
I/O link is not correct.
Stops
⇒Re-configure the I/O map for slave
stations according to the I/O points of
the slave stations.
When reading in the program from the
IC memory card(due to automatic
reading because of the dip switch
setting or program switching due to
F14(PGRD) instruction):
- IC memory card is not installed.
- There is no program file or it is
damaged.
Stops
- Writing is disabled.
- There is an abnormality in the
AUTOEXEC.SPG file.
- Program size stored on the card is
larger than the capacity of the CPU.
⇒Install an IC memory card that has
the program proterly recorded and
execute the read once again.
Abnormal I/O unit.
FPΣ, FP-X:
Check the contents of special data
register DT90002 and abnormal FPΣ
expansion unit (application cassette for
FP-X). Then check the unit.
FP2 and FP2SH:
Check the contents of special data
registers DT90002,DT90003 and
abnormal I/O unit.Then check the unit.
Selection of operation status using
system register21:
-to continue operation,set 1
-to stop operation,set 0
Verification is possible in FPWIN
Sele-
GR/Pro at"I/O error" in the status
ctable
display function.
MEWNET-TR communication error
FP3 and FP10SH:
Check the contents of special data
registers(FP3:DT9002,DT9003,FP10S
H:DT90002,DT90003) and the
erroneous master unit and abnormal
I/O unit. Then check the unit.
Selection of operation status using
system register21:
-to continue operation,set 1
-to stop operation,set 0
Verification is possible in FPWIN
GR/Pro at"I/O error" in the status
display function.
A A A
A A
A A A A A
A:Available
A
A