Mitsubishi Electric IQSS-R-E Reference Manual page 174

Backup folder/file
New backup folders are created in the 'ASLINK' folder which exists in the 'Backup' folder under the main folder of '$MELPRJ$'
in an SD memory card when data is backed up.
If no '$MELPRJ$' folder, 'Backup' folder, or 'ASLINK' folder exists, each of the folders are created as well when data is backed
up.
Up to 100 backup folders (date_number) can be created in the 'ASLINK' folder.
■Backup folder configuration
The following figure shows the backup folder configuration in an SD memory card.
/
$MELPRJ$
(1) A folder to save the settings of devices supporting iQSS connected to AnyWireASLINK
(2) Backup folder (date_number)
(3) Backup folder (start I/O No._ID)
(4) Backup data (information of each ID)
■Backup folder name
• Date_Number
YYYYMMDD_**
YYYY: Year when the data was backed up (four digits in decimal)
MM: Month when the data was backed up (two digits in decimal)
DD: Day when the data was backed up (two digits in decimal)
**: Number (two digits in decimal (00 to 99))
*1 If multiple folders with the same number exist while a target folder (0 to 99) is set to SD1363 (iQ Sensor Solution backup/restoration
folder number setting), the date of the backup folder name may not be updated. (Setting a number for a data backup folder name)
• Start I/O No._ID
****_OUT_****
First ****: Start I/O number (four digits in hexadecimal) (A value obtained by dividing the start I/O number by 16)
OUT: Output slave module, or IN_: Input slave module/I/O combined slave module
Last ****: Start ID number (four digits in decimal)
■Backup file name
ID_OUT_****.QBR
OUT: Output slave module, or IN_: Input slave module/I/O combined slave module
****: ID number (four digits in decimal)
7 AnyWireASLINK
172
7.4 Backing up/Restoring Data of Devices Supporting iQSS
(1)
Backup ASLINK
*1
(2) (3)
20160101_00
0001_OUT_0001
20160102_01
0001_OUT_0001
0001_IN__0064
20160102_02
(4)
ID_OUT_0001.QBR
$BKUP_UNIT_INF.BSI
ID_OUT_0001.QBR
$BKUP_UNIT_INF.BSI
ID_IN__0064.QBR
$BKUP_UNIT_INF.BSI