Considerations when detecting devices connected to a bridge module
■Address setting for a device supporting iQSS
To use an iQ Sensor Solution function in a device supporting iQSS which is connected to a bridge module (NZ2AW1C2AL),
set the setting required for communication (such as address setting and amplifier teaching) in advance.
Make sure that the address occupied by a device supporting iQSS is set so as not to exceed the number of transmission
points set for a bridge module (NZ2AW1C2AL).
(CC-Link-AnyWireASLINK Bridge Module User's Manual)
8 CC-Link
202
8.1 Detecting Devices Supporting iQSS Automatically
The "AnyWireASLINK Configuration" window appears.
3.
Click the [Detect Now] button.
4.
When an automatic address detection is required, select the
"Execute Detect Now after Address Auto-recognition"
checkbox, then click the [Yes] button.
For a case in which an automatic address detection is required,
refer to the following manual.
CC-Link-AnyWireASLINK Bridge Module User's Manual
The actual system configuration is displayed in the
"AnyWireASLINK Configuration" window.
5.
Select [Close with Saving the Setting] in the "AnyWireASLINK
Configuration" window.
The setting of the "AnyWireASLINK Configuration" window is
saved and the window is closed.