Shipping The System; System Startup; Ac Tray Panel; Plugging In The System - Siemens Acuson S1000 Instructions For Use Manual

Shipping the System

When shipping the system, perform the following tasks, as appropriate.
To prepare the system for shipment over long distances or rough terrain:
1. Repack the system in the factory packaging and crate according to the instructions shown
on the container.
2. Load the system into a vehicle using a lift gate.
– To prevent lateral movement of the system, secure the system with cargo straps.
– To prevent sudden jarring of the system during transport, provide shock cushions
beneath the system.

System Startup

WARNING: Operating the ultrasound system in close proximity to other equipment can cause
reciprocal interference. You should observe and ensure normal operation of the ultrasound
system and other equipment.
The first step to operating the ultrasound system is to connect the system to a power source.

AC Tray Panel

The AC tray panel on your system may have a connector cover for protection of the power
cord.
Example of AC Tray panel with a connector cover.

Plugging in the System

WARNING: Before connecting the ultrasound system to a power supply, you must read and
understand the Electrical Safety section of Chapter 2, Instructions for Use.
The ultrasound system has a non-detachable power cord.
To plug in the system:
Connect the power cord plug to the MAINS supply in the following manner:

– 230V systems to a 230V standard MAINS, i.e., "Schuko" receptacle
(CEE 7-7 standard).
– 115V systems to a hospital-grade MAINS receptacle.
–
100V systems to a standard 100V MAINS receptacle.
I n s t r u c t i o n s f o r U s e
1 Power cord connector
2 Equipotential connector
3 Service diagnostic lights
4 MAINS circuit breaker
I = ON
 = OFF
3 S y s t e m S e t u p
3 - 7