Table 3. Ethernet port indicator codes
Convention
A
B
C
D
Sled to hard drive mapping
Figure 5. Sled to drive mapping for the enclosure with 24 x 2.5 inch drives
1
drives 0–5 mapped to sled 1
3
drives 12–17 mapped to sled 3
5
(optional) NVMe hard drive location
NOTE:
The warranty of the drives are linked to the Service Tag of the corresponding sled.
Locating the Service Tag of your system
Your system is identified by a unique Express Service Code and Service Tag number. The Express Service Code and Service Tag are found
on the back of the sled by pulling out the EST tag. This information is used by Dell EMC to route support calls to the appropriate personnel.
Figure 6. Locating the Service Tag of your system
1
information tag (top view)
3
information tag (bottom view)
10
XC6420 Series overview
Status
Link and activity indicators are off
Link indicator is green
Link indicator is amber
Activity indicator is flashing green
Condition
The NIC is not connected to the network.
The NIC is connected to a valid network at its
maximum port speed.
The NIC is connected to a valid network at less than
its maximum port speed.
Network data is being sent or received.
2
drives 6–11 mapped to sled 2
4
drives 18–23 mapped to sled 4
2
Express Service Tag label
4
network MAC address information label