Figure 27. Installing the riser card
Next steps
1
If removed,
install the expansion
2
Install the expansion card riser
3
Install the sled
into the enclosure.
4
Follow the procedure listed in
M.2 SATA drive
The BOSS card is a simple RAID solution card designed specifically for booting a server's operating system. The card supports up to two 6
Gbps M.2 SATA drives. The BOSS adapter card has a x8 connector using PCIe gen 2.0 x2 lanes, available only in the low-profile and half-
height form factor.
Removing the M.2 SATA x16 riser
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
3
Remove the sled
from the enclosure.
Steps
1
Using the Phillips #1 screwdriver, loosen the screw that secures the riser to the sled.
2
Lift the riser up to disengage the riser from the connector on the system board.
3
Disconnect the data cable from the riser.
70
Installing and removing system components
card.
assembly.
After working inside your
system.
Safety
instructions.
Before working inside your
system.