Air Shroud; Removing The Air Shroud - Dell E43S Series Installation And Service Manual

Figure 12. Installing a sled blank
Next step
Follow the procedure listed in
NOTE: To add the Service Tag of the system board to match the Service Tag of the physical node, contact Dell EMC Technical
Support.

Air shroud

The air shroud aerodynamically directs the airflow across the sled. The airflow passes through all the critical parts of the sled, where the
fans push the air across the entire surface area of the heat sink. There is a vacuum created by air pulled across the hard drives, thus
allowing increased cooling.

Removing the air shroud

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the sled from the enclosure.
Steps
1 Press the clip on the air shroud to release the shroud from the sled.
2 Remove the shroud by rotating the shroud and releasing the hinge from the slot on the system.
54 Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.