Table of Contents
Advertisement
NOTE:
NVMe drive slots are 6, 7, 8, and 9. XC640-4 does not support NVMe drives.
Drive slot numbering is 0 relative for chassis. All NVMe drives are installed in the last slots. Maximum of four NVMe drives are supported.
Topics:
•
Setting up your system
•
iDRAC configuration
•
Methods to download firmware and drivers
Setting up your system
Complete the following steps to set up your system:
About this task
NOTE:
Do not change any of the factory settings.
Steps
1
Unpack the system.
2
Install the system into the rack. For more information about installing the system into the rack, see the Rail Installation Guide at
Dell.com/XCSeriesmanuals.
3
Connect the peripherals to the system.
4
Connect the system to its electrical outlet.
5
Turn the system on by pressing the power button or by using iDRAC.
6
Turn on the attached peripherals.
For more information about setting up your system, see your Getting Started Guide shipped with your system.
iDRAC configuration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall
availability of Dell EMC systems. iDRAC alerts administrators to system issues, helps them perform remote system management, and
reduces the need for physical access to the system.
Options to set up iDRAC IP address
You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC.
You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP
for iDRAC. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
utility
24
Initial system setup and configuration
Initial system setup and configuration
4
Hide quick links:
Advertisement
Table of Contents
