Figure 20. Removing the expansion card riser assembly
Next step
Install the expansion card riser
Installing the expansion card riser assembly
Prerequisite
NOTE:
You must install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling
and airflow inside the system.
Follow the safety guidelines listed in
Steps
1
Place the expansion card assembly into the system board assembly.
2
Align the riser card connector with the connector on the system board, and press the expansion card riser assembly into place.
3
Using the Phillips #2 screwdriver, tighten the screws that secure the expansion card riser assembly.
assembly.
Safety
instructions.
Installing and removing system components
63