Handling The Machine Data - Siemens SINUMERIK 804D sl Commissioning Manual

SCALING_FACTOR_USER_DEF_MASK,
SCALING_FACTOR_USER_DEF and
SCALING_SYSTEM IS METRIC = 1.
If the machine data is not based on an engineering unit, then the field is marked with "-".
Default value
The machine data/setting data is preset to this value.
Note
Inputs via HMI are limited to ten digits plus comma and sign.
Value range (minimum and maximum)
Specifies the input limits. If no range of values is specified, the data type determines the
input limits and the field is marked with "∗∗∗".
15.6.2

Handling the machine data

Introduction
To display and input machine data, appropriate screen forms are provided.
Example
Selection of displays:
When yóu press the Area Switchover key on the HMI, the menu bar appears with the
following areas: Machine, Parameter, Program, Services, Diagnostics and Installation and
Start-Up. Press Installation and Start-Up and then Machine data.
Note
For the input of machine data, the protection level 2 password "EVENING" has to be set at
the least.
Screen editor for HEX machine data
A bit editor has been implemented to simplify the matter of setting certain machine data bits.
If the input cursor is on a machine data in HEX format in the MD list, you can call up the
editor by pressing the toggle key (in the middle of the cursor keys).
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
Fundamentals
15.6 Machine and setting data
281