Tips; Configuration Of The Properties Of The Network Interface For Profibus - Siemens SINUMERIK 804D sl Commissioning Manual

Tips

13.1

Configuration of the properties of the network interface for PROFIBUS

Introduction
In the STEP7 project, you configure the network interfaces PROFIBUS DP, via which you
want to reach the machine control panel:
Steps for PROFIBUS DP
1. You used the left mouse button to select NCU 720.1 and while holding down the mouse
2. After you release the mouse button, configure the properties of PROFIBUS DP interface
Figure 13-1
3. Click the following menu items one after the other:
4. Select the transmission rate "12 Mbps" for the "DP" profile (see figure below).
CNC Part 1 (NCK, PLC, drive)
Commissioning Manual, 11/2006, 6FC5397-2AP10-2BA0
button you dragged it to the "Station design" station window.
for socket X126 (machine control panel) in the dialog box (see figure below).
Properties of PROFIBUS DP
– the "New..." button,
– the "Network settings" tab in the "Properties new subnet PROFIBUS Subnet" dialog
box.
13
185